- Oilfield Auxiliary
Non-Ionic Polyacrylamide for Water Treatment and Mining
Polyacrylamide, Non-Ionic Polyacrylamide, Polyacrylamide for Water Treatment manufacturer / supplier in China, offering Non-Ionic Polyacrylamide for Water Treatment and Mining, Most Famous Water Decoloring Agent in China, Polyaluminium Chloride (PAC 30%, 28%) and so on.
Welcome to consult non-ionic polyacrylamide for water treatment and mining price with Shandong Tongli Chemical Co.,Ltd, which is one of the leading non-ionic polyacrylamide for water treatment and mining suppliers in China and also a productive non-ionic polyacrylamide for water treatment and mining factory.
Model NO.: NON - PAM
Type: Sewage Treatment Chemicals
HS Code: 39069010
Acid-Base Property: Neutral Surface Disposal Agent
Environmental Protection: Yes
Package: 25kg Kraft Paper Bag
Our Non-Ionic Polyacrylamide is used for water treatment and mining industries.
|Appearance:||Off-White Granular Powder|
|Particle Size:||20-100 mesh|
|Anionic Degree:||Very Low|
|Solid Content:||89% Minimum|
|Bulk Density:||About 0.8|
|Specific Gravity at 25°C:||1.01-1.1|
|Recommended Working Concentration:||0.1-0.5%|
|Storage Temperature (°C):||0 - 35|
|Shelf Life:||2 Years|
Economical to use- Effective at very low dosage levels, resulting in reduced handling and storage cost.
Works over a wide pH range and does not alter pH in the system.
Larger, faster-settling flocs are formed in gravity settling operations.
Increased filtration rates and drier cakes are produced in filtration processes. Sludges contain less ash when incinerated.
Higher solids capture, increased clarity, and greater throughput are attained in centrifugation.
Air flotation operations produce clearer underflows and grater throughput.
Municipal and industrial water treatment
Clarification industrial raw waters, often in conjunction with in organics such as Alum
Alum sludge dewatering.
Preparation for Application:
Any grade of Nonionic flocculant should be dissolved in water under low agitation to make 0.01% to 0.05 % solution. Dissolution should be complete after 60 minutes, but will be faster in warm water. However avoid temperature above 500° C. Stock solutions are stable for at least two weeks. For best results further dilution with clean water should be made prior to being fed to process stream. Avoid turbulent mixing conditions in the process stream after any grade of above product has been added.
For use as:
FlocculantO. 2 ~ 2.0 ppm.
Coagulant aidO. 5 ~ 1.0 ppm.
Filtration aidO. 01 ~1.0 ppm.
Sludge dewateringO. 05 ~O. 2 % Dry solid
Spilled polymer is very slippery. Spills should be scooped and / or wiped prier to flushing with water. Being highly hygroscopic avoid from exposure to air.
Please Note the information presented here is based on best of our present knowledge. However should not be considered as guarantee of any specific property or product as a whole.
25kg/plastic enhanced paper bags with inner plastic bag, 25kg/PE bag